A ‘How To’ Guide to Interior and Exterior House Painting
Painting both the interior and exterior of a house will not only refresh peeling, dirty paintwork, but will also maintain the beauty and life of the wood, render, or wall plaster.
Preparation in house-painting is the key to success. Interior walls should be washed with sugar soap to remove all traces of grease and dirt and then thoroughly rinsed with clean water. Any flaking plaster or cracks will need to be sanded down and re- filled with plaster. It is possible to buy ready made filler suitable for plaster which is really easy to use. Interior wood also needs to be cleaned with sugar soap, rinsed, and then sanded with a fine grade glass paper to give the new paint a surface on which to grip. If you just paint over existing paintwork without preparing the surface, the paint may flake and peel off!
It is personal choice on whether to paint the woodwork first or the walls. Generally, it is best to paint the emulsion on the walls first as emulsion does not always 'take' over gloss paint.
Once all the preparation has been completed on the walls and any filler rubbed smooth with fine glass paper - begin painting! When painting a light color over a dark existing color it is best to use an undercoat of white. Either that or be prepared to give the walls two or three coats of paint to ensure full coverage. Nothing looks worse than pale walls with the dark color showing through; it looks most unprofessional and you will not be happy with the result. Start by painting the wall from the top down, this will enable you make sure there are no paint runs in the finished wall.
After the woodwork has been prepared, begin painting from the top of the room down. Use a good quality primer on new wood, followed by the undercoat. When re-painting over existing paintwork it is best to use a 'one coat' gloss paint which is readily available from DIY shops and most hardware stores.
In painting windows, use masking tape to cover a small strip of the four edges of the glass. Paint from the top down to avoid drips and runs. Be mindful not to put too much paint on the brush as this will produce drips and runs. Also do not try to spread the paint too thinly as this will leave unsightly brush marks. Do not be tempted to pull off the masking tape for at least 24 hours; otherwise it will be a waste of time using it!
When you paint doors it is advisable to also begin painting at the top and work downwards; use a final up and down stroke of the brush to blend the paint in the same direction to help remove brush lines.
Don't forget to paint the baseboards! Use the same approach of preparation then painting.
When painting the exterior of the house, all old and flaking paint or rendering needs to be dealt with first. Once this has been removed begin painting either by hand, which is an arduous task or by using a paint sprayer. Which ever method is chosen it is advisable to cover the ground below and any features on the house with old newspaper or sheeting. Begin at the top and systematically work downwards.
Exterior woodwork should also be rubbed down with glass paper before attempting to paint. Work with a systematic approach from the top down. Try not to chose a windy day for painting outside woodwork otherwise you will end up with dust particles sticking to the wet paint!
By: Jonathan D Hunt
About the Author:
Jonathan Hunt is a free-lance writer and creates websites He is interested in running, writing, and personal development.
Interest in Interior Wall Painting
You do not need to be a professional painter in order to have some knowledge about indoor painting and the proper methods that should be used. As long as you have an interest in painting, you will automatically end up knowing these things, and ultimately, applying them. The main purpose of painting a wall is to make the interior of a home look more appealing and welcoming. The original designs that you eventually create are a representation of who you are and what your tastes are. Bear this fact in mind every time you start to redecorate the surfaces in your home. Always strive to do the best job that you are able to.
It is very important to remember is that the selection of paints, as well as the proper painting tools, is the most important step in this entire process. The choices that you make will ultimately determine, to a large extent, whether or not your artistic creation will ever achieve the intended aesthetic and functional goals that you have set for it.
Some people prefer the unique finish that can only be obtained by using a sponge as the painting instrument of choice. The sponges that should be used are, of course, the natural ones. Synthetic sponges bring about, to a certain extent, unsatisfactory results. After all the time and effort that has to be expended in this endeavor, no one wants to be disappointed with the results; especially if it is just because an artificial sponge was used.
On the other hand, many people are really attracted to any wall that has been painted using the rag technique; they consider this effect to be very appealing. Different types of materials will produce an assortment of "one of a kind" finishes. Therefore, it is always a good idea to experiment with several dissimilar fabrics until you stumble on the one that grabs your attention the most. Texture is the determining factor here. Your individual likes and dislikes will influence your decision regarding this characteristic.
It should go without saying that any excess paint that may have been inadvertently left on the wall surface should be quickly wiped off before it has a chance to thoroughly dry. Otherwise, it will destroy the creative outcome of the whole painting undertaking. Remember, only gentle pressure should ever be applied when trying to remove any of the surplus paint. Drippings on the ceiling and floor areas must also be promptly cleaned off before they become a permanent testimony to your unprofessional approach to painting.
Always try to keep this thought in mind; a few moments of carelessness can totally ruin hours and hours of hard work.
By: Jonathan R Richards
About the Author:
Interior House Painting – Masking Tape – Tips and Tricks
Painting walls is one of the largest tasks when painting the interior of a house. This article will help shed some light on a few tips and tricks to using masking tape to paint great looking walls.
With interior house painting, having nicely painted walls is important. The typical way of painting walls is to first 'cut-in' the edges with a brush and then fill in the center areas by rolling the paint on. For the beginner or average DIY person cutting-in is typically done using tape to mask off the edges of the painted wall; paint is then applied without much accuracy in hopes that when the masking tape is removed the freshly painted wall will have a clean edge. Usually the outcome is less than desirable and the problem can at times be attributed to the tape being applied improperly, luckily there are a few ways to improve the results of tape when used for interior house painting work.
When applying the tape, apply it gently without stretching or over-pulling. This gives the tapes adhesive a better chance to do its job and stick more fully to the surface it's being applied to, reducing the amount of paint that can seep under the edge. Once the tape has been gently applied, press the tape onto the surface using a rag. Occasionally with some uneven or bumpy surfaces the tape can be punctured by the surface irregularity but in most interior house painting applications the surface is relatively smooth so there shouldn't be a problem. The rag helps to disperse the pressure and again allows the adhesive to more fully adhere to the surface and prevent paint seepage.
When painting your wall with a brush, start brushing and spreading the paint next to the tape before painting directly onto the tape. Once you've spread some paint on the wall next to the tape line brush the paint in-line with the tape instead of brushing directly into the tape. This will reduce the likelihood of paint seeping under the tape and/or paint being forced under the tape by the brush.
There are also a couple of tricks to painting with masking tape, these tricks are only really applicable to interior house painting but can really make a difference and will change most peoples opinions of tape I believe. If you have the same color of paint that the tape is protecting, you can paint this color onto the tape before painting your new color. This will fill in any gaps in the tape, so when you apply your new color all the gaps and paint seepage areas have already been filled with the color beneath.
Another trick is to use caulking in a similar fashion as above. Take clear caulking, mix it 4:1 with water and apply this mixture to the tape before applying your finish top-coat. Be sure to let this dry, what this does is similar to the double paint layer, it fills in the gaps and prevents paint from seeping under the tape.
When removing your tape, pull it slowly and at a sharp angle away from the painted surface. It's best to remove the tape when the paint is fresh (after a second coat or if you're only doing one coat) as the paint has yet to dry and create a seal. It's wise to always invest in decent quality products, some tapes have stronger adhesives or are made for specific uses, never be afraid to ask for advice from a home improvement or paint store. Typically you'll find people versed in the ways of interior house painting working at these places, especially a paint store!.
Remember to be safe, read about your products and adhere to all safety and cautionary procedures. I hope these tips help to improve your interior house painting projects!
By: A H Young
About the Author:
Interior Painting – 5 Color Ideas For Your Painting Project
Have you seen interior walls that are uninviting and dull? Well, say goodbye to those walls because it is now possible to have a welcoming and cozy room each time you arrive from work. You will probably need good color ideas to go about your interior painting.
1. To start with, if you decide to use decorative painting more than one room inside the house, try to get varying tints of the color that you want to paint and that includes the plain color.
2. If one of your rooms have existing fabrics but you really want it to be updated, you can paint the wall with the similar color or shade by using a fresh technique. You should also match the finishes to every room's unique style.
3. For your private retreats such as your bedroom, use a special paint finish because this is the place where you usually spruce up or calm down. Be sure to choose a color that unifies with your furniture; this can enhance the entire decorating look which you can enjoy to the fullest.
4. If you prefer latex paint, well, they provide a tough finish. If you use it together with varnish, you can use it for many applications. It dries quickly, safe, and is odorless.
5. If you go for neutral colors, you can use them as backdrops. Some people prefer to use them alone because these neutral colors generate a harmonious design. And because the color doesn't change suddenly, they create a different impression of space and light.
Don't rush yourself, in fact, try to take time and experiment on different color combinations for your interior painting. Remember, in order to achieve your desired effect or finish, you must purchase the right type and amount of paint.
By: Tim Lee
About the Author:
Interior Paint Problems
Covering Stains, Grease, Graffiti, and Problem Surfaces.
Most folks find out about stains and problem surfaces after it is too late -- during, or after they are done, painting. Repeated coats of paint won't cover properly because the problem areas bleed through the new paint.
Special Problem Areas
Old paint, oil or lead based
Grease, oil, mold, or mildew
Graffiti, ball point ink, permanent markers, paint
Bad plaster, crumbling or water damaged
Old oil and lead base paints often used special pigments that bleed through new latex paints. Light colors might not bleed at all while some darker colors cannot be covered even with several coats of paint. You can test a small area, let it dry for 24 hours, and check for coverage.
To seal the old paint, you need to use a special primer. Normally, it will be an oil base primer especially made to cover oil base paint before painting with latex paint. Be sure to get one designed for this purpose. Be sure to follow the directions for drying time before applying the first coat of paint.
Grease, oil, mold, or mildew should be cleaned with a household cleaner first. Next, clean with a solution made for use before painting, such as Soilax. You can purchase it at a paint or hardware store. After the soiled areas are dry, paint them will a special primer designed for hiding these kind of spots.
Porters--Stay-Kill--primer works well. You can prime the entire surface, or just cover up the soiled areas. Be sure to follow the directions for drying time before applying the first coat of paint.
Graffiti, ball point ink, permanent markers, and paint can be covered with a special primer designed for hiding these kinds of spots. Porters Stay-Kill primer works well. You need to cover the soiled areas. Be sure to follow the directions for drying time before applying a second coat of primer or the first coat of paint.
Bad plaster, crumbling or water damaged needs to be cleaned first. Use a scrub brush and water to remove all the loose plaster. If there's extensive damage, you should repair the damaged plaster, too. Water damage causes some of the chemicals in plaster to bleed through new paint. It's a good idea to use a primer like Porters Stay-Kill before painting. Be sure to follow the directions for drying time before applying a second coat of primer or the first coat of paint.
Painting tips
Buy good quality paint. Porters are one of the brands that are good, however, other name brands are good, too, and have similar types of primers and paints.
In kitchens, bathrooms, and high-traffic areas, use a "latex enamel" paint which is more waterproof and can be cleaned easily.
Allow plenty of drying time for a primer, and between each coat of paint. Getting in a hurry might end up with a poor finish, or require an additional coat of paint.
If you're trying to get by with just one coat of paint, don't apply it to heavy. If a second coat is needed, you will have wasted paint.
If you plan to use two coats of paint, don't put the first coat on too thin. Two even coats will look better and last longer.
Be sure you have plenty of ventilation. If you're painting your home, plan to does it during warm weather so you can leave the windows open during, and for several days after, painting?
By: Mario Sanchez
About the Author:
How-to information on painting and other aspects of home improvement.. Includes do-it-yourself guide, and links.
Read more interior painting problem on:
DIY Home Improvement Information
http://www.painterclick.com/interior_painting_problems.htm
Water Filters - Reverse Osmosis
| Wagner 9155 3000 PSI Airless Twin Stroke Piston Pump Paint Sprayer |
 |
Overall Rating: |
| Retail Price: $409.99 |
| Amazon Price: $409.99 |
Recent Posts
- Colored Concrete Sealers
- A ‘How To’ Guide to Interior and Exterior House Painting
- Interest in Interior Wall Painting
- Concrete Sealers
- Interior House Painting – Masking Tape – Tips and Tricks
- Interior Painting – 5 Color Ideas For Your Painting Project
- Top 8 Home Security Alarms According to Google(TM) Search
- Home Security – Auto Dialer Intruder Alarm Review
- Interior Paint Problems
- Painting Concrete Basement Walls – Add Colorful Spice to Your Basement
- Home Security Alarm Systems
- 4 Most Common Problems with Home Security Alarms
- The Importance of a Home Security Alarm
- Interior Painting Color Scheme
- Home Security Alarm System And Comfort
Categories
- Alarms & Security
- Alternative Energy – Solar – Wind – Geothermal – Water
- Concrete
- Electrical
- Kitchen Improvements
- New Construction
- Painting
- Plumbing Repairs
- Power Tools
Resources
Tags
Lightword Theme by Andrei Luca Go to top ↑
